Toyota Corolla 2008 year remote key programming steps
Toyota Vios / Corolla 2008 year remote key programming steps:
Step 1: the car should be in the following status:
a. Insert the key into the ignition
b. Only open the driver's door
Step 2: operate as follows, choose the module you want.
a. Insert the key into the ignition and pull out 2 times within 5 seconds.
b. Close and open the driver's door for 2 times (End with opening), then insert the key into the ignition and pull it out.
c. Close and open the driver's door for 2 times (end with opening), insert the key into the ignition and close the car doors.
d. Turn the ignition LOCK-ON-LOCK for one times, then pull out the key from ignition.
e. At this time, the ECU will automatically lock and unlock the door within 5 seconds.
f. within 40 seconds, on the original car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then get your hand off，finally press any of the two buttons for 1 second.
g. within 5 seconds after you get your hand off, if successfully register it will automatically operate "lock" and "unlock" for one time; if fail to register it will automatically execute 2 times "lock" and "unlock" operation.
h. on the new car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then off your hand, followed is to press any of the two buttons over 1 second, within 5 seconds after you off your hand, if successfully register it will automatically operate "lock" and "unlock" for one time.
Step 1: the car should be in the following status:
a. Insert the key into the ignition
b. Only open the driver's door
Step 2: operate as follows, choose the module you want.
a. Insert the key into the ignition and pull out 2 times within 5 seconds.
b. Close and open the driver's door for 2 times (End with opening), then insert the key into the ignition and pull it out.
c. Close and open the driver's door for 2 times (end with opening), insert the key into the ignition and close the car doors.
d. Turn the ignition LOCK-ON-LOCK for one times, then pull out the key from ignition.
e. At this time, the ECU will automatically lock and unlock the door within 5 seconds.
f. within 40 seconds, on the original car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then get your hand off，finally press any of the two buttons for 1 second.
g. within 5 seconds after you get your hand off, if successfully register it will automatically operate "lock" and "unlock" for one time; if fail to register it will automatically execute 2 times "lock" and "unlock" operation.
h. on the new car remote controller press the "lock" and "unlock" button for 1-1.5 seconds at the same time, then off your hand, followed is to press any of the two buttons over 1 second, within 5 seconds after you off your hand, if successfully register it will automatically operate "lock" and "unlock" for one time.