Warm Tips to Use VXSCAM V3 Automotive Smoke Leak Detector

---

Matched product:

How to Operate the Automotive Smoke Leak Detector

1.Fill 10ml-20ml test oil to the detector.
2.Disconnect the intake pipe of the car. Connect the intake pipe of the car with the detector.
3.Connect detector with DC12V battery, it starts to work.
4.The pipe will be filled with smoke.Check the leak points.


2 Mode: No need to buy extra air compressor
Air Mode: Press the AIR MODE, pump starts working, only after this, you may press and start the SMOKE MODE. It can help you test whether there is a leak in the pipe by injecting air into the pipe, and judge by the sound made when the air leaks.
Smoke Mode: After pressing this switch, the power indicator light is on to indicate that the power supply is normal. It helps you lacate the leak accuarately through the visible smoke. The smoke can be produced within seconds, dramatically reducing diagnostic time.


Overheat & Anti-frost Protection: Built in self-protective system
V3 EVAP vacuum tester is equipped with the latest intelligent protection device.
When the temperature of the device exceeds 70 degrees Celsius, the power protection device will be intelligently activated to turn it off, to ensure the safety of the operator and the device.
The device is also suitable for low temperature operation.


Notice before Leak Test
Turn OFF the Ignition of Your Vehicle.
It can't be connected to the 12v power supply in the office, or it cannot output the smoke.It just support a 12V battery with a current range of 8A-10A (Ordinary car batteries are eligible).


Fast Smoke Output
This machine built-in air compressor, with superior wick and heating element.
It can produce smoke instantly by heating up Johnson baby oil pink label. 4ft Smoke Outlet Pipe can help reach and connect perfectly.
Note: Use the Johnson baby oil pink label is the best choice if available.