FVCI is a PASS-THRU device of FCAR. It supports J2534 protocol, and it will support other protocol for free later. FVCI J2534 supports multiply communication manner of DOIP protocol, and it can setup Ethernet(tx_+, tx_-, rx_+, rx_-) and active line to any pin number of OBD2 except for ground pins and power pin.
FCAR FVCI PassThru J2534 Reflash/Diagnostics VCI
FVCI is a PASS-THRU device of FCAR. VCI use 3 ARM microcontrollers design, this will make the processing capacity of FVCI stronger and support OEM software better. It supports J2534 protocol, and it will support other protocol for free later. In addition, the hardware of FVCI supports multiply communication manner of DOIP protocol, and it can setup Ethernet(tx_+, tx_-, rx_+, rx_-) and active line to any pin number of OBD2 except for ground pins and power pin.
FVCI J2534 Diagnostic and Programming
Three ARM microcontrollers.
Three individual physical communication channels for protocols(CAN, single wire CAN, KWP, PWM, VPW, SCI and so on).
Ethernet converts to OBD2 for DOIP protocol, the pins(tx_+, tx_-, rx_+, rx_-, active line) can set any pin number of OBD2 except for ground pins and power pin.
Program voltage output between 5v and 20v.
One Ethernet port.
One analog input port.
Fcar FVCI Passthru Specification:
FVCI J2534 Support Function:
JARGUR LANDROVER JLR SDD
Chrysler, Dodge, Jeep, Eagle, Plymouth
Ford, Lincoln, Mercury
FVCI Device Interface:
1) DC 12V/1A
2) Network port
3) USB port
4) Update pin, use for firmware update
5) Analog input
6) Programming voltage supply, 5V-20V, 120ma
7) Vehicle communication port
8) Device power status lamp
9) Software of device running status lamp
10) Vehicle communication status lamp
11) Network connection status lamp
12) USB connection status lamp
How to Update Fcar FVCI J2534 Passthru Software & Firmware?
1. Click “FVCI” icon on the desktop. Note: The computer must be connected to internet.
2. Click “Read Version” can read FVCI software and hardware version.
3. Click “Firmware Update” can update the hardware.
4. Click “Software Update” can update the software.
5. Click”DOIP”, then click “Enter DOIP mode”, the FVCI will enter the situation of Ethernet convert to OBD2 of DOIP.
6. Click ”Firmware Refresh” when you operate“firmware update” error.
1) Please enable internet connection before upgrade
2) The firmware version and software version must be the newest version meanwhile. Otherwise the device will appear some error.
3) If you use “Firmware update” failed, you can use “Firmware refresh”.
Contact Information:Whatsapp: +86-13995696053Email: email@example.comSkype: UOBD2.COM Shipping Method and Delivery Time:US, UK, Amazon and Russia Warehouse Shipping:
3-5 working days. Fast Delivery No Tax.
US Check: Ship from US
EU Check: Ship from UK
Russia Check: Ship from RUDHL Shipping:
3-4 working days. Usually we declare a lower price on DHL invoice to help with customs clearance. If your address belongs to remote area, customer will need to pay remote handling cost or we will change to ship by EMS. Please remember to leave message if you have any special requirement.Yanwen Express:
5-10 working days. No Tax or remote cost for European Countries.Standard Post:
Order under $150 normally with default shipping Standard Post, customers can tick for Express Shipping Service to ship by DHL.